1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Fuse in Philco 610 Tombstone
Steve D
Member
***
Posts: 115
Threads: 25
Joined: Jul 2006
City: Lebanon, NJ 08833
#6

09-15-2017, 05:03 PM
I prefer chassis a mounted fuse holder for which I can usually find a spot to affix near the AC line cord entry.  Here is one example (zoom in on lower right corner):

http://galleries.mine.nu/steves/gallery/...520?full=1

Steve D
Find
« Next Oldest | Next Newest »


Messages In This Thread
Fuse in Philco 610 Tombstone - by bikenepa - 09-14-2017, 10:06 AM
RE: Fuse in Philco 610 Tombstone - by Radioroslyn - 09-14-2017, 11:41 AM
RE: Fuse in Philco 610 Tombstone - by bikenepa - 09-14-2017, 11:48 AM
RE: Fuse in Philco 610 Tombstone - by Radioroslyn - 09-14-2017, 12:01 PM
RE: Fuse in Philco 610 Tombstone - by Steve D - 09-15-2017, 05:03 PM
RE: Fuse in Philco 610 Tombstone - by bikenepa - 09-18-2017, 03:14 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration