Philco 41-300 output transformer question.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 41-300 output transformer question.

Tomie
Junior Member

Posts: 19
Threads: 2
Joined: Sep 2017
City: Little Elm State, Province, Country: Texas

10-03-2017, 06:11 PM

Morzh

Thanks. Do you know how to determine the low end characteristics of the Zenith and or Hammond transformers? I won't trash the Zenith speaker to remove the transformer, it belongs in another set.
So my speaker is basically 8 ohms, (I think the DC resistance on the voice coil was something like 5.? ohms.) I originally use 1 and 4 terminals then 2 and 4, etc. No difference. Lots of sound, just very low quality sound.
Is this Philco radio known for low quality sound issues?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 41-300 output transformer question. - by Tomie - 10-03-2017, 03:02 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-03-2017, 04:22 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-03-2017, 06:11 PM

RE: Philco 41-300 output transformer question. - by Radioroslyn - 10-03-2017, 07:53 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-03-2017, 10:34 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-04-2017, 03:51 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-04-2017, 03:59 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-04-2017, 05:52 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-04-2017, 06:39 PM

RE: Philco 41-300 output transformer question. - by Ron Ramirez - 10-04-2017, 07:38 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-04-2017, 08:06 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-06-2017, 04:59 PM

RE: Philco 41-300 output transformer question. - by Steve D - 10-06-2017, 05:27 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-06-2017, 08:04 PM

RE: Philco 41-300 output transformer question. - by Electrothaumaturgist - 10-09-2017, 03:32 AM

RE: Philco 41-300 output transformer question. - by Tomie - 10-23-2017, 07:30 PM

RE: Philco 41-300 output transformer question. - by Radioroslyn - 10-23-2017, 09:04 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me