Speaker rebuilding

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Speaker rebuilding

BILL
Member

Posts: 160
Threads: 36
Joined: Jan 2006

01-23-2006, 07:33 PM

OK this may have been gone over before but I'm new to the Philco Phorum I have a 1930 Transitone auto radio my speaker is beat- needs to be reconed and the coils are open, this speaker is very similar ,design wise, to the old Atwater Kent cone speakers of the 1920's ,magnet and pin, high impedance , the cone is the heavier material than newer speakers and is quite shallow anyone got Ideas?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Speaker rebuilding - by BILL - 01-23-2006, 07:33 PM

[No subject] - by Chuck Schwark - 01-23-2006, 08:18 PM

[No subject] - by BILL - 01-30-2006, 05:40 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 5373 online users. [Complete List]
» 2 Member(s) | 5371 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me