1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Crosley 106CP Modulation Hum
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#13

10-07-2017, 02:50 PM
Something else that came to mind is to try some snap on ferrite cores over the line cord. This may help reduce incoming rfi from the house wiring.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Crosley 106CP Modulation Hum - by Raleigh - 10-02-2017, 01:56 PM
RE: Crosley 106CP Modulation Hum - by Raleigh - 10-02-2017, 08:00 PM
RE: Crosley 106CP Modulation Hum - by Radioroslyn - 10-03-2017, 04:24 AM
RE: Crosley 106CP Modulation Hum - by Raleigh - 10-03-2017, 05:35 PM
RE: Crosley 106CP Modulation Hum - by Arran - 10-03-2017, 11:07 PM
RE: Crosley 106CP Modulation Hum - by Raleigh - 10-04-2017, 12:12 PM
RE: Crosley 106CP Modulation Hum - by Radioroslyn - 10-04-2017, 01:02 PM
RE: Crosley 106CP Modulation Hum - by Mondial - 10-05-2017, 05:52 AM
RE: Crosley 106CP Modulation Hum - by Arran - 10-06-2017, 12:10 AM
RE: Crosley 106CP Modulation Hum - by Raleigh - 10-07-2017, 09:08 AM
RE: Crosley 106CP Modulation Hum - by Radioroslyn - 10-07-2017, 02:50 PM
RE: Crosley 106CP Modulation Hum - by Arran - 10-09-2017, 02:26 AM
RE: Crosley 106CP Modulation Hum - by Raleigh - 10-11-2017, 04:44 PM
RE: Crosley 106CP Modulation Hum - by Raleigh - 10-19-2017, 05:29 PM
RE: Crosley 106CP Modulation Hum - by Ron Ramirez - 10-20-2017, 10:55 AM
RE: Crosley 106CP Modulation Hum - by morzh - 10-20-2017, 11:44 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

[-]
Who's Online
There are currently 4117 online users. [Complete List]
» 2 Member(s) | 4115 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)