Philco 41-300 output transformer question.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 41-300 output transformer question.

Electrothaumaturgist
Senior Member

Posts: 481
Threads: 18
Joined: Jan 2013
City: Mesa, AZ

#15

10-09-2017, 03:32 AM

That's so disappointing to hear. That 41-300 looks so similar to the 42-400 I restored a few years back... Looks to be about the same speaker in it (though I may be wrong), but mine was a total basket case, as was the speaker (had major holes in it... I fixed the speaker (and everything else), and the sound was absolutely impressive! Did you replace ALL crumbling wires? That baby should be belting it out! There were some caps and rotten wires under the push button sector that are tough to get to. I hope you isolate the problem, and good luck!!!

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 41-300 output transformer question. - by Tomie - 10-03-2017, 03:02 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-03-2017, 04:22 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-03-2017, 06:11 PM

RE: Philco 41-300 output transformer question. - by Radioroslyn - 10-03-2017, 07:53 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-03-2017, 10:34 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-04-2017, 03:51 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-04-2017, 03:59 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-04-2017, 05:52 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-04-2017, 06:39 PM

RE: Philco 41-300 output transformer question. - by Ron Ramirez - 10-04-2017, 07:38 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-04-2017, 08:06 PM

RE: Philco 41-300 output transformer question. - by Tomie - 10-06-2017, 04:59 PM

RE: Philco 41-300 output transformer question. - by Steve D - 10-06-2017, 05:27 PM

RE: Philco 41-300 output transformer question. - by morzh - 10-06-2017, 08:04 PM

RE: Philco 41-300 output transformer question. - by Electrothaumaturgist - 10-09-2017, 03:32 AM

RE: Philco 41-300 output transformer question. - by Tomie - 10-23-2017, 07:30 PM

RE: Philco 41-300 output transformer question. - by Radioroslyn - 10-23-2017, 09:04 PM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me