Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 48-1274
#2

HI David,
First off, your set should be able to be repaired by replacing those filter capacitors, then the smaller 'wax' capacitors.

There are basically 2 types of collectors. One that wants a set recapped and working, or a collector who likes an 'unmolested' or worked on set. They would rather recap and do the work themselves. The selling price will obviously be lower for an unrestored set, compared to one that has been properly restored.

It is hard to give a value, it all depends on who is buying and what your bottom line is. IN addition, some of the consoles with a phonograph installed go for a lower value tha ones without. The photographs are a different aspect in restoring as they have rubber wheels that have dried up or worn out, the cartridge probably needs a rebuild too.

I am going to go out on a limb here and guess, in the shape your set is in, and to a collector, you may get between $50 and $100, again depending on your area, and the buyer's mood Icon_smile

So, if you have the set restored by a "pro", will the cost exceed the selling price? Is the buyer someone like a decorator looking for one working set, who might pay a higher price?
Or, do you plan to keep the set, have it restored and use it for what it was intended for? If this is the only set you have, I think you'd be happy with it. Who else do you that has a (potentially) resotred working console radio. with phono? There is just something about the old sets, the smell and the sound that you can't duplicate.

If you are not going to keep the set, personally, I'd sell it like it is, but make sure the person knows that it will need new capacitors, and simply adding a cord will not bring the set back to life. It could be downright dangerous.

Sorry to be so vague, but hopefully my ramblings helped Icon_smile
Gary.


Messages In This Thread
Philco 48-1274 - by Guest - 03-13-2010, 02:22 PM
Re: Philco 48-1274 - by gary rabbitt - 03-16-2010, 12:19 AM
Re: Philco 48-1274 - by Guest - 03-16-2010, 11:47 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>