Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New here 46-1203
#4

Thanks! Soldering and I are on pretty good terms, from my other mechanicing. Ohm meters and I have yet to meet, but my car can get the Harbor Freight and three different hardwares without me, so I will be looking into that shortly! Icon_biggrin 

Thanks so much for the warm welcome! 
Dolly


Messages In This Thread
New here 46-1203 - by Dolly - 10-27-2017, 02:06 AM
RE: New here 46-1203 - by morzh - 10-27-2017, 08:31 AM
RE: New here 46-1203 - by Radioroslyn - 10-27-2017, 12:32 PM
RE: New here 46-1203 - by Dolly - 10-27-2017, 02:38 PM
RE: New here 46-1203 - by Dolly - 10-27-2017, 02:44 PM
RE: New here 46-1203 - by klondike98 - 10-27-2017, 07:44 PM
RE: New here 46-1203 - by CodyTerry - 10-28-2017, 10:09 AM
RE: New here 46-1203 - by Squire - 10-28-2017, 12:30 PM
RE: New here 46-1203 - by Jim421 - 11-12-2017, 08:02 PM
RE: New here 46-1203 - by morzh - 11-12-2017, 08:32 PM
RE: New here 46-1203 - by Jim421 - 11-12-2017, 10:25 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

[-]
Who's Online
There are currently 3375 online users. [Complete List]
» 1 Member(s) | 3374 Guest(s)
Avatar

>