Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith ID...288??
#8

(11-06-2017, 12:45 PM)w4rtc Wrote:  PJohn
Look at the ad that you put up, I think it says available in two console versions.
Joe

Good eye Joe!  Since I can't find a console 288 in any of my Zenith literature, I wonder if the that store was putting the chassis in custom cabinets for customers?

   

Skip, it looks like your set managed to keep all six of the factory knobs!

John KK4ZLF
Lexington, KY
"illegitimis non carborundum"


Messages In This Thread
Zenith ID...288?? - by vecher - 11-05-2017, 07:43 PM
RE: Zenith ID...288?? - by vecher - 11-05-2017, 08:35 PM
RE: Zenith ID...288?? - by vecher - 11-05-2017, 08:35 PM
RE: Zenith ID...288?? - by Radioroslyn - 11-05-2017, 10:31 PM
RE: Zenith ID...288?? - by Fred Taylor - 11-06-2017, 08:32 AM
RE: Zenith ID...288?? - by Eliot Ness - 11-06-2017, 09:20 AM
RE: Zenith ID...288?? - by w4rtc - 11-06-2017, 12:45 PM
RE: Zenith ID...288?? - by Eliot Ness - 11-06-2017, 02:41 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently no members online.

>