1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Hello! 38-12 Dial Question
Radioroslyn
Phorum Expert
*****
Posts: 7,287
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#8

11-07-2017, 08:53 PM
Most of the ones I've seen aren't crimped along the edges but have little snap in fasteners near the corners. Remove 3 or 4 of them and the dial card come off. I would take your new dial place a suitable piece of clear plastic over it then use the two original screws to remount it. Or takev your tin and turn it the other way around. Put the new dial on the backside. Use the original screws to remount w/ a plastic on the front to prevent rash.

[Image: http://northernelectric.ca/radios/philco...t_orig.jpg]
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 11-07-2017, 08:56 PM by Radioroslyn.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Hello! 38-12 Dial Question - by Shaleradio - 11-03-2017, 08:20 PM
RE: Hello! 38-12 Dial Question - by Ron Ramirez - 11-04-2017, 08:58 AM
RE: Hello! 38-12 Dial Question - by Radioroslyn - 11-04-2017, 02:49 PM
RE: Hello! 38-12 Dial Question - by morzh - 11-04-2017, 07:47 PM
RE: Hello! 38-12 Dial Question - by klondike98 - 11-04-2017, 08:34 PM
RE: Hello! 38-12 Dial Question - by Shaleradio - 11-05-2017, 09:12 PM
RE: Hello! 38-12 Dial Question - by Shaleradio - 11-07-2017, 08:17 PM
RE: Hello! 38-12 Dial Question - by Radioroslyn - 11-07-2017, 08:53 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently 6326 online users. [Complete List]
» 1 Member(s) | 6325 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration