1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Chassis vernier removal question
xwarp
Junior Member
**
Posts: 9
Threads: 3
Joined: Nov 2017
City: Tucson AZ
#4

11-09-2017, 11:46 PM
Sorry, yes for the 37-675.

I figured out that I did not need to remove it. I tried a little sewing machine oil and it loosened the vernier shaft up really nicely.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Chassis vernier removal question - by xwarp - 11-09-2017, 11:01 PM
RE: Chassis vernier removal question - by w4rtc - 11-09-2017, 11:24 PM
RE: Chassis vernier removal question - by xwarp - 11-09-2017, 11:46 PM
RE: Chassis vernier removal question - by xwarp - 11-09-2017, 11:50 PM
RE: Chassis vernier removal question - by Arran - 11-10-2017, 05:00 AM
RE: Chassis vernier removal question - by 462ron - 11-10-2017, 08:46 AM
RE: Chassis vernier removal question - by xwarp - 11-10-2017, 02:02 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4894 online users. [Complete List]
» 1 Member(s) | 4893 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration