1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Fuse question
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#6

11-12-2017, 11:25 PM
Just as an aside I found these online. Physically they are fairly small abt 3/4"long and come in .5,1,and 2amp sizes among others. .79c for a box of 5. A bit of tubing over it and it's good to go, no holder to mount.


Attached Files Image(s)
   
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 11-12-2017, 11:27 PM by Radioroslyn.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Fuse question - by Shaleradio - 11-12-2017, 06:34 PM
RE: Fuse question - by morzh - 11-12-2017, 06:51 PM
RE: Fuse question - by jcassity - 11-12-2017, 08:09 PM
RE: Fuse question - by morzh - 11-12-2017, 08:35 PM
RE: Fuse question - by Shaleradio - 11-12-2017, 09:56 PM
RE: Fuse question - by Radioroslyn - 11-12-2017, 11:25 PM
RE: Fuse question - by jcassity - 11-13-2017, 08:47 AM
RE: Fuse question - by Shaleradio - 11-13-2017, 10:06 AM
RE: Fuse question - by Jim Dutridge - 11-16-2017, 06:31 PM
RE: Fuse question - by WallaceRoger - 11-17-2017, 01:48 PM
RE: Fuse question - by Phlogiston - 11-17-2017, 02:59 PM
RE: Fuse question - by morzh - 11-17-2017, 03:22 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration