1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
A Philco 91 restore
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#22

11-13-2017, 07:04 PM
> Does anyone know if a 2 watt 220 ohm resistor would work OK in the circuit? Thanks! 
Did a quick calculation and 2w is plenty, came up w/abt .25w.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
A Philco 91 restore - by klondike98 - 01-10-2017, 02:36 PM
RE: A Philco 91 restore - by sam - 01-10-2017, 02:57 PM
RE: A Philco 91 restore - by morzh - 01-10-2017, 03:09 PM
RE: A Philco 91 restore - by klondike98 - 01-10-2017, 03:48 PM
RE: A Philco 91 restore - by morzh - 01-10-2017, 04:49 PM
RE: A Philco 91 restore - by Radioroslyn - 01-11-2017, 12:55 AM
RE: A Philco 91 restore - by klondike98 - 01-11-2017, 09:08 AM
RE: A Philco 91 restore - by morzh - 01-11-2017, 01:20 PM
RE: A Philco 91 restore - by Ron Ramirez - 01-11-2017, 01:21 PM
RE: A Philco 91 restore - by morzh - 01-11-2017, 01:25 PM
RE: A Philco 91 restore - by klondike98 - 01-11-2017, 05:55 PM
RE: A Philco 91 restore - by Nathan Slingerland - 01-11-2017, 06:14 PM
RE: A Philco 91 restore - by klondike98 - 01-11-2017, 06:16 PM
RE: A Philco 91 restore - by klondike98 - 01-12-2017, 01:11 PM
RE: A Philco 91 restore - by Ron Ramirez - 01-12-2017, 01:20 PM
RE: A Philco 91 restore - by Radioroslyn - 01-12-2017, 01:45 PM
RE: A Philco 91 restore - by klondike98 - 01-12-2017, 02:12 PM
RE: A Philco 91 restore - by Mondial - 01-12-2017, 06:18 PM
RE: A Philco 91 restore - by klondike98 - 01-12-2017, 08:42 PM
RE: A Philco 91 restore - by klondike98 - 11-13-2017, 05:09 PM
RE: A Philco 91 restore - by Steve Davis - 11-13-2017, 05:56 PM
RE: A Philco 91 restore - by Radioroslyn - 11-13-2017, 07:04 PM
RE: A Philco 91 restore - by klondike98 - 11-13-2017, 08:12 PM
RE: A Philco 91 restore - by klondike98 - 11-16-2017, 04:15 PM
RE: A Philco 91 restore - by klondike98 - 11-09-2018, 05:02 PM
RE: A Philco 91 restore - by klondike98 - 11-11-2018, 06:50 PM
RE: A Philco 91 restore - by Ron Ramirez - 11-12-2018, 12:23 AM
RE: A Philco 91 restore - by klondike98 - 11-12-2018, 08:35 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM

[-]
Who's Online
There are currently 6482 online users. [Complete List]
» 1 Member(s) | 6481 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration