Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Ship radio Woes
#8

I had the idea that maybe they were using that transformer as a voltage dropper, perhaps by using one of the windings in series with the tube filaments. Before I found out that this set had it's tubes wired in series I had the idea that maybe they were using it as a filament transformer.
Regards
Arran


Messages In This Thread
Ship radio Woes - by OldRestorer - 11-15-2017, 09:06 PM
RE: Ship radio Woes - by OldRestorer - 11-15-2017, 09:08 PM
RE: Ship radio Woes - by Radioroslyn - 11-15-2017, 11:19 PM
RE: Ship radio Woes - by Arran - 11-16-2017, 02:41 AM
RE: Ship radio Woes - by jcassity - 11-17-2017, 06:51 AM
RE: Ship radio Woes - by OldRestorer - 11-18-2017, 03:08 PM
RE: Ship radio Woes - by OldRestorer - 11-18-2017, 11:36 PM
RE: Ship radio Woes - by Arran - 11-19-2017, 01:18 AM
RE: Ship radio Woes - by Paul Philco322 - 11-19-2017, 08:08 PM
RE: Ship radio Woes - by OldRestorer - 11-20-2017, 03:49 AM
RE: Ship radio Woes - by Radioroslyn - 09-26-2018, 11:10 PM
RE: Ship radio Woes - by Eliot Ness - 09-27-2018, 07:56 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>