Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Minding My Beeswax... RF style
#14

I think clear nail polish is just "thick" clear lacquer anyway. I've used it too. Also to dab over a repair on a single coil lug re-connect.


Messages In This Thread
[No subject] - by Robbie Roberts - 01-21-2006, 01:39 AM
[No subject] - by Ron Ramirez - 01-21-2006, 01:50 AM
[No subject] - by Chuck Schwark - 01-21-2006, 10:57 AM
[No subject] - by Robbie Roberts - 01-21-2006, 01:44 PM
Yup, it's beewax - by AI2V - 01-21-2006, 02:03 PM
[No subject] - by Robbie Roberts - 01-21-2006, 02:07 PM
USP beeswax melting point - by AI2V - 01-23-2006, 12:44 PM
[No subject] - by Robbie Roberts - 01-23-2006, 02:27 PM
[No subject] - by 49Stude63 - 01-24-2006, 05:45 PM
[No subject] - by Robbie Roberts - 01-24-2006, 05:47 PM
[No subject] - by Chuck Schwark - 01-25-2006, 12:05 AM
[No subject] - by Bill Hutchinson - 01-26-2006, 11:39 AM
[No subject] - by Chuck Schwark - 01-26-2006, 11:51 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6299 online users. [Complete List]
» 1 Member(s) | 6298 Guest(s)
Avatar

>