Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

A Philco 91B
#2

That little edge of the front laminate is always falling off just above the router cut for the arch. I have patched so many of those on Philcos, but the same is true for Crosleys.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
A Philco 91B - by klondike98 - 12-13-2017, 12:45 PM
RE: A Philco 91B - by Phlogiston - 12-13-2017, 01:02 PM
RE: A Philco 91B - by Arran - 12-14-2017, 05:46 AM
RE: A Philco 91B - by Steve Davis - 12-14-2017, 11:33 AM
RE: A Philco 91B - by Phlogiston - 12-16-2017, 12:16 PM
RE: A Philco 91B - by klondike98 - 10-01-2018, 04:29 PM
RE: A Philco 91B - by Radioroslyn - 10-01-2018, 09:31 PM
RE: A Philco 91B - by Greggshere - 10-06-2018, 11:26 PM
RE: A Philco 91B - by klondike98 - 11-01-2018, 03:01 PM
RE: A Philco 91B - by KCMike - 11-01-2018, 04:34 PM
RE: A Philco 91B - by klondike98 - 11-12-2018, 09:32 PM
RE: A Philco 91B - by klondike98 - 11-13-2018, 03:07 PM
RE: A Philco 91B - by OldRestorer - 11-14-2018, 09:45 AM
RE: A Philco 91B - by morzh - 11-14-2018, 03:42 PM
RE: A Philco 91B - by Ron Ramirez - 11-14-2018, 04:33 PM
RE: A Philco 91B - by morzh - 11-14-2018, 04:50 PM
RE: A Philco 91B - by klondike98 - 11-14-2018, 05:30 PM
RE: A Philco 91B - by klondike98 - 11-15-2018, 05:38 PM
RE: A Philco 91B - by KCMike - 11-15-2018, 07:03 PM



Users browsing this thread: 10 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>