Philco 38-690 electronics restoration.
Posts: 284
Threads: 18
Joined: Nov 2016
City: Cromwell
State, Province, Country: CT
The grommets need to go on two small shafts on the front of the sub chassis before it's installed in the main chassis. Then you slide the front of the sub into the two openings in the mounting bracket and slide back. So these brackets have elongated rails for the grommets.
I'll try to get pictures from mine later today.
Messages In This Thread
RE: Philco 38-690 electronics restoration. - by tbone - 12-17-2017, 11:34 AM
Users browsing this thread: 3 Guest(s)
|
Recent Posts
|
Zenith H725
|
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM |
Zenith H725
|
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM |
My Philco 37-116 Restore
|
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM |
My Philco 37-116 Restore
|
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM |
Philco 610B oscillator wiring
|
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM |
Refinishing Ideas
|
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM |
My Philco 37-116 Restore
|
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM |
Zenith H725
|
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM |
Philco model #20
|
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM |
Zenith H725
|
Hello Ed,
yes, I like letting projects run for few days to make sure they don't start acting up .
Sincerely Richardradiorich — 01:03 PM |
Who's Online
|
There are currently 798 online users. [Complete List] » 1 Member(s) | 797 Guest(s)
|
|
|

|