Arvin 442 cap question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Arvin 442 cap question

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

12-25-2017, 05:33 PM

OBTW these caps are polarized (they have a + and -) and it is very important that they are installed in the proper polarity. The schematic doesn't show it. Here's a quick drawing. All of the -'s are connect together and go back to the off/on switch.

Attached Files Image(s)

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Arvin 442 cap question - by Foose - 12-25-2017, 12:18 PM

RE: Arvin 442 cap question - by Phlogiston - 12-25-2017, 01:10 PM

RE: Arvin 442 cap question - by Radioroslyn - 12-25-2017, 01:10 PM

RE: Arvin 442 cap question - by Foose - 12-25-2017, 04:13 PM

RE: Arvin 442 cap question - by Radioroslyn - 12-25-2017, 05:33 PM

RE: Arvin 442 cap question - by Phlogiston - 12-25-2017, 06:18 PM

RE: Arvin 442 cap question - by Arran - 12-25-2017, 10:56 PM

RE: Arvin 442 cap question - by Foose - 12-27-2017, 04:37 PM

RE: Arvin 442 cap question - by Radioroslyn - 12-27-2017, 07:35 PM

RE: Arvin 442 cap question - by Foose - 12-28-2017, 04:07 PM

RE: Arvin 442 cap question - by Foose - 12-30-2017, 07:03 PM

RE: Arvin 442 cap question - by Radioroslyn - 12-31-2017, 12:39 AM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM

Who's Online

There are currently 5017 online users. [Complete List]
» 1 Member(s) | 5016 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me