Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-620
#1

Hello everyone. I'm new here.  I hope you all have a great New Year!!  I've been reading some of the posts and was looking for some advice.  About 20 years ago I bought a Philco 37-620 in good condition. Just needed some cosmetics. I ran a couple of "tandum" wires where I saw questionable wiring on top (and replaced the power cord) the year I bought it.  You can see them in the picture (but left original wires in place). It has worked great for years. Here is the advice I need.  If it works fine...should I change out any components like capacitors for potential fire hazard?

I have it out of the cabinet to repair the speaker cone (mover put a finger through it)  Thank you for your help!

Alan
Burrke, VA


Attached Files Image(s)
           


Messages In This Thread
Philco 37-620 - by Alan - 12-27-2017, 09:15 PM
RE: Philco 37-620 - by Radioroslyn - 12-27-2017, 09:56 PM
RE: Philco 37-620 - by klondike98 - 12-27-2017, 10:08 PM
RE: Philco 37-620 - by Alan - 12-28-2017, 01:02 AM
RE: Philco 37-620 - by morzh - 12-28-2017, 01:11 AM
RE: Philco 37-620 - by Radioroslyn - 12-28-2017, 02:51 AM
RE: Philco 37-620 - by Alan - 12-30-2017, 11:23 PM
RE: Philco 37-620 - by Alan - 12-30-2017, 11:35 PM
RE: Philco 37-620 - by Radioroslyn - 12-30-2017, 11:55 PM
RE: Philco 37-620 - by Alan - 01-07-2018, 10:33 PM
RE: Philco 37-620 - by klondike98 - 01-08-2018, 09:59 AM
RE: Philco 37-620 - by Alan - 01-08-2018, 10:29 PM
RE: Philco 37-620 - by klondike98 - 01-08-2018, 10:39 PM
RE: Philco 37-620 - by Ron Ramirez - 01-09-2018, 07:27 AM
RE: Philco 37-620 - by klondike98 - 01-09-2018, 10:16 AM
RE: Philco 37-620 - by Alan - 01-09-2018, 10:54 PM
RE: Philco 37-620 - by klondike98 - 01-09-2018, 11:04 PM
RE: Philco 37-620 - by Radioroslyn - 01-09-2018, 11:23 PM
RE: Philco 37-620 - by Alan - 01-10-2018, 07:19 AM
RE: Philco 37-620 - by Ron Ramirez - 01-10-2018, 07:23 AM
RE: Philco 37-620 - by Alan - 01-10-2018, 11:32 PM
RE: Philco 37-620 - by Radioroslyn - 01-11-2018, 12:21 PM
RE: Philco 37-620 - by Ron Ramirez - 01-11-2018, 12:46 PM
RE: Philco 37-620 - by Alan - 01-11-2018, 10:28 PM
RE: Philco 37-620 - by Arran - 01-12-2018, 12:02 AM
RE: Philco 37-620 - by Alan - 01-14-2018, 10:59 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM
Philco Predicta Siesta picture over time getting dimmer
I found that the wire insulation was burnt.  The fly back needs corona dope! Why would someone put that there?Platinumblonde36 — 01:09 AM
Philco Predicta Siesta picture over time getting dimmer
This is what it looked like beforePlatinumblonde36 — 01:01 AM
Philco Predicta Siesta picture over time getting dimmer
Platinumblonde36 — 12:58 AM
Philco Predicta Siesta picture over time getting dimmer
Platinumblonde36 — 12:57 AM
Philco Predicta Siesta picture over time getting dimmer
I'm finding some strange things in my set and for the most part it's also original, so I need to start going over everyt...Platinumblonde36 — 12:55 AM
12' Philco
Not anymore Mike. Andre The Giant Born: May 19, 1946, Coulommiers, France Died: Jan 28, 1993 (46 years), Paris, Fran...RodB — 11:53 PM

[-]
Who's Online
There are currently 4237 online users. [Complete List]
» 3 Member(s) | 4234 Guest(s)
AvatarAvatarAvatar

>