Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Rippled underlayment fix
#2

See if you can get some hypodermic needless and syringes, and lots of bar clamps, if you can inject glue into the lifting areas and clamp them down with some flat blocks of wood, be sure to warp the blocks in plastic so they don't get stuck to the piece.
Regards
Arran


Messages In This Thread
Rippled underlayment fix - by madsowry - 02-09-2018, 11:21 PM
RE: Rippled underlayment fix - by Arran - 02-10-2018, 05:07 AM
RE: Rippled underlayment fix - by oscartg - 04-13-2018, 05:24 PM
RE: Rippled underlayment fix - by Phlogiston - 04-13-2018, 07:39 PM
RE: Rippled underlayment fix - by Arran - 04-14-2018, 02:50 AM
RE: Rippled underlayment fix - by oscartg - 04-14-2018, 09:38 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM

[-]
Who's Online
There are currently 7586 online users. [Complete List]
» 1 Member(s) | 7585 Guest(s)
Avatar

>