Philco 70 volume issue

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 70 volume issue

Radiowilbur
Junior Member

Posts: 25
Threads: 11
Joined: Jan 2016
City: Lake Winola, PA

#12

02-10-2018, 08:51 PM

....i tested both controls with an ohm meter out of the circuit, i even dismantled the back section of the control. each operated smoothly from 0 to their maximum and with correct readings. if you connect to the center pin of either control and measure from either end and then the other, all the readings were smooth and without interruption, glitches or intermittants. zero to 250 and zero to 5K. i believe the control is in good shape. it is a wire wound type and it is clean Philco part by CTS. I think the problem lies elsewhere.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 70 volume issue - by Radiowilbur - 02-10-2018, 11:21 AM

RE: Philco 70 volume issue - by bzadel - 02-10-2018, 01:32 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 01:48 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-10-2018, 01:49 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 01:50 PM

RE: Philco 70 volume issue - by morzh - 02-10-2018, 02:17 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 03:15 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 04:52 PM

RE: Philco 70 volume issue - by morzh - 02-10-2018, 05:23 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-10-2018, 07:08 PM

RE: Philco 70 volume issue - by Ron Ramirez - 02-10-2018, 08:07 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-10-2018, 08:51 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-10-2018, 08:53 PM

RE: Philco 70 volume issue - by Ron Ramirez - 02-10-2018, 10:48 PM

RE: Philco 70 volume issue - by morzh - 02-10-2018, 10:57 PM

RE: Philco 70 volume issue - by Ron Ramirez - 02-11-2018, 12:22 AM

RE: Philco 70 volume issue - by morzh - 02-11-2018, 12:27 AM

RE: Philco 70 volume issue - by Radiowilbur - 02-11-2018, 01:21 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-11-2018, 04:30 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-11-2018, 07:25 PM

RE: Philco 70 volume issue - by Radiowilbur - 02-11-2018, 08:23 PM

RE: Philco 70 volume issue - by Radioroslyn - 02-11-2018, 10:38 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 3847 online users. [Complete List]
» 1 Member(s) | 3846 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me