Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1937 Ford F-1442 Philco car radio
#1

I'm working on a 1937 Ford car radio, model F-1442 and my manual for the radio does not seem to have any instructions for alignment. I need to know where to hook up the signal generator to align the radio. I can hear static through the speaker but so far no radio signals at all and I have been working replacing the old wax paper capacitors. I need to know which tube, and what pin I connect to, I am going to guess the number 78 tube at 260 KC but I want to verify that.


Messages In This Thread
1937 Ford F-1442 Philco car radio - by flatheadjr - 02-14-2018, 04:08 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
I'm starting to restore a Philco 16X, I need spare parts. Help me find it
Peter; Are you certain you wouldn't like the Deforest Crosley instead? It's probably the most "Canadian" of...Arran — 08:14 PM
What is this?
It would not be the first time someone among us misidentified a part. I can remember working on a Sonora AC/DC set where...Arran — 08:04 PM
What is this?
I restored the original post. It may be useful to someone in the future.klondike98 — 02:26 PM
I'm starting to restore a Philco 16X, I need spare parts. Help me find it
Michael, this is one of the five radio consoles from Canada from my companion that I received for restoration and that I...RadioSvit — 10:16 AM
What is this?
You can probably save it using coils on the wire leads. Try unwinding a tad off each end of the rf coil.RodB — 09:47 PM
What is this?
Yes, thanks.  I kinda figured that out LOL.    I thought I knew what it was until I cut it out.  Coulda, woulda, shoulda...MissouriLarry — 08:35 PM
I'm starting to restore a Philco 16X, I need spare parts. Help me find it
Where did you get this one from? I have restored same exact 16X about 2 years ago, the thread is here. morzh — 06:29 PM
What is this?
Before yanking anything, especially if you don't know what it is, find out what it is. As Rod said, it is an RF coil. H...morzh — 06:26 PM
What is this?
Solder it back in, I can't find it on the schematic but it's probably an rf choke. You should identify parts in the sch...RodB — 03:39 PM
What is this?
I was starting to replace the paper capacitors in my Philco 46-1213 today.  My first piece I think I made a mistake.  I ...MissouriLarry — 11:05 AM

[-]
Who's Online
There are currently 1485 online users. [Complete List]
» 2 Member(s) | 1483 Guest(s)
AvatarAvatar

>