1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-1 grille cloth
Brad Winder
Senior Member
****
Posts: 330
Threads: 30
Joined: Aug 2017
City: Hay Lakes, Alberta,Canada
#11

03-04-2018, 01:46 PM
Looks good!!!

I too have several radios here, with original grille cloth, that have the pattern slightly crooked or off center. As Ron said, most radios were built fast on an assembly line, and went out the door with what were considered "acceptable imperfections".
Find
« Next Oldest | Next Newest »


Messages In This Thread
38-1 grille cloth - by Electrothaumaturgist - 01-26-2018, 10:38 PM
RE: 38-1 grille cloth - by Ron Ramirez - 01-26-2018, 11:35 PM
RE: 38-1 grille cloth - by Electrothaumaturgist - 01-27-2018, 12:14 AM
RE: 38-1 grille cloth - by Electrothaumaturgist - 02-02-2018, 09:27 PM
RE: 38-1 grille cloth - by Electrothaumaturgist - 03-01-2018, 05:27 PM
RE: 38-1 grille cloth - by Ron Ramirez - 03-01-2018, 07:11 PM
RE: 38-1 grille cloth - by Electrothaumaturgist - 03-01-2018, 07:56 PM
RE: 38-1 grille cloth - by Electrothaumaturgist - 03-02-2018, 06:45 PM
RE: 38-1 grille cloth - by Ron Ramirez - 03-02-2018, 07:12 PM
RE: 38-1 grille cloth - by Electrothaumaturgist - 03-02-2018, 07:53 PM
RE: 38-1 grille cloth - by Brad Winder - 03-04-2018, 01:46 PM
RE: 38-1 grille cloth - by Kenneth F. Besso Jr. - 03-04-2018, 02:35 PM
RE: 38-1 grille cloth - by Electrothaumaturgist - 03-04-2018, 03:51 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4839 online users. [Complete List]
» 1 Member(s) | 4838 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration