1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
40-180 Voltage High
Bruce C
Junior Member
**
Posts: 14
Threads: 1
Joined: Mar 2010
#27

05-12-2010, 07:06 PM
I do not have an isolation transformer or variac yet, not in the budget. I would imagine not all isolation transformers are the same and in the simpliest form my not filter but just isolate. Just using a dim bulb tester and meter for now, which reminds me I have a Kill a Watt meter at the cabin that would show me the load also when using the DBT.

The Y2 caps are very large and didn’t put them in for that reason so I will get some X1/Y2 caps.

Thanks for your replys.
Find
« Next Oldest | Next Newest »


Messages In This Thread
40-180 Voltage High - by Bruce C - 03-29-2010, 04:20 PM
Re: 40-180 Voltage High - by DeckApe - 03-30-2010, 08:36 AM
Re: 40-180 Voltage High - by Bruce C - 03-30-2010, 09:48 AM
Re: 40-180 Voltage High - by rghines1 - 03-30-2010, 04:48 PM
Re: 40-180 Voltage High - by Bruce C - 03-30-2010, 06:18 PM
Re: 40-180 Voltage High - by rghines1 - 03-31-2010, 03:58 PM
Re: 40-180 Voltage High - by Bruce C - 03-31-2010, 09:32 PM
Re: 40-180 Voltage High - by Bruce C - 04-04-2010, 06:16 PM
Re: 40-180 Voltage High - by rghines1 - 04-05-2010, 07:47 AM
Re: 40-180 Voltage High - by Bruce C - 04-05-2010, 06:34 PM
Re: 40-180 Voltage High - by exray - 04-05-2010, 09:40 PM
Re: 40-180 Voltage High - by Raleigh - 04-05-2010, 09:59 PM
Re: 40-180 Voltage High - by exray - 04-05-2010, 10:26 PM
Re: 40-180 Voltage High - by codefox1 - 04-06-2010, 01:12 PM
Re: 40-180 Voltage High - by Bruce C - 04-06-2010, 04:08 PM
Re: 40-180 Voltage High - by Bruce C - 04-20-2010, 04:47 PM
Re: 40-180 Voltage High - by Bruce C - 04-26-2010, 04:36 PM
Re: 40-180 Voltage High - by Ron Ramirez - 04-26-2010, 04:51 PM
Re: 40-180 Voltage High - by denver - 04-26-2010, 06:28 PM
Re: 40-180 Voltage High - by Bruce C - 04-30-2010, 12:35 PM
Re: 40-180 Voltage High - by exray - 05-01-2010, 01:36 AM
Re: 40-180 Voltage High - by Bruce C - 05-07-2010, 10:03 AM
Re: 40-180 Voltage High - by codefox1 - 05-08-2010, 09:45 AM
Re: 40-180 Voltage High - by Raleigh - 05-12-2010, 01:09 PM
Re: 40-180 Voltage High - by Bruce C - 05-12-2010, 07:06 PM
Re: 40-180 Voltage High - by Bruce C - 05-12-2010, 07:06 PM
Re: 40-180 Voltage High - by Bruce C - 05-12-2010, 07:06 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM
40-150 General questions
I think RobB has it right. It is a part number and looks like its stamped on the chassis and that wasn't something you ...klondike98 — 11:41 AM
40-150 General questions
It's most likely a part number. Most of Philco part numbers are in that format. I looked at the parts list for this mode...RodB — 08:10 AM

[-]
Who's Online
There are currently 3619 online users. [Complete List]
» 3 Member(s) | 3616 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration