42-380 alignment

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

42-380 alignment

whirligig
Junior Member

Posts: 38
Threads: 5
Joined: Feb 2017
City: manhattan beach, CA

03-25-2018, 05:16 PM

(03-25-2018, 04:19 PM)spiderdrummer24 Wrote: Meter is good but that may be my issue. I don't have the adaptor for DC. Only AC voltages. I have another multimeter. I'll try and get a reading on it

On my Heathkit V7, I replaced the DC connector to a BNC which made easier to connect to probes and test leads. Lately I just use a DMM since the input impedance of even the cheap ones are 1 meg or better. However, analog meters are easier to spot the max deflection than a bunch of moving digits.

Find

« Next Oldest | Next Newest »

Messages In This Thread

42-380 alignment - by spiderdrummer24 - 03-25-2018, 01:20 PM

RE: 42-380 alignment - by morzh - 03-25-2018, 02:44 PM

RE: 42-380 alignment - by Radioroslyn - 03-25-2018, 02:54 PM

RE: 42-380 alignment - by spiderdrummer24 - 03-25-2018, 04:19 PM

RE: 42-380 alignment - by whirligig - 03-25-2018, 05:16 PM

RE: 42-380 alignment - by Radioroslyn - 03-25-2018, 07:09 PM

RE: 42-380 alignment - by whirligig - 03-25-2018, 10:29 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me