Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 604 Bias Cell
#8

Thanks, all, for the help with this. I am going to recap the rf unit, (not sure how, yet) and then tackle this battery issue. Since I am going to sell the radio, I am loathe to pass on a battery problem to the next owner. Among the suggestions, I like the coin cell idea as much as any. If I go that way, I will probably obtain one of those little plastic coin cell holders and put a 2032 in there. Still, I'd be giving my new owner a service liability sometime in the next 5-10 years.

Does anyone know what the symptoms are for a dead bias cell? No audio? Garbled audio? Early tube failure? Wondering how a person would know when it is time to replace the cell.


Messages In This Thread
Philco 604 Bias Cell - by mboessen - 03-28-2018, 03:37 PM
RE: Philco 604 Bias Cell - by morzh - 03-28-2018, 05:02 PM
RE: Philco 604 Bias Cell - by mboessen - 03-28-2018, 08:28 PM
RE: Philco 604 Bias Cell - by PhilcoPhan1936 - 03-29-2018, 04:16 AM
RE: Philco 604 Bias Cell - by Arran - 03-29-2018, 05:12 AM
RE: Philco 604 Bias Cell - by David - 03-29-2018, 08:24 AM
RE: Philco 604 Bias Cell - by Radioroslyn - 03-29-2018, 08:44 AM
RE: Philco 604 Bias Cell - by mboessen - 03-29-2018, 09:24 AM
RE: Philco 604 Bias Cell - by 462ron - 03-29-2018, 10:12 AM
RE: Philco 604 Bias Cell - by morzh - 03-29-2018, 10:47 AM
RE: Philco 604 Bias Cell - by mboessen - 03-29-2018, 10:57 AM
RE: Philco 604 Bias Cell - by mboessen - 03-29-2018, 11:00 AM
RE: Philco 604 Bias Cell - by 462ron - 03-29-2018, 01:34 PM
RE: Philco 604 Bias Cell - by mboessen - 03-29-2018, 03:06 PM
RE: Philco 604 Bias Cell - by mboessen - 03-29-2018, 09:31 PM
RE: Philco 604 Bias Cell - by mboessen - 03-29-2018, 09:39 PM
RE: Philco 604 Bias Cell - by Radioroslyn - 03-29-2018, 10:14 PM
RE: Philco 604 Bias Cell - by 462ron - 03-29-2018, 10:30 PM
RE: Philco 604 Bias Cell - by Radioroslyn - 03-29-2018, 11:04 PM
RE: Philco 604 Bias Cell - by mboessen - 03-30-2018, 08:49 AM
RE: Philco 604 Bias Cell - by 462ron - 03-30-2018, 10:07 AM
RE: Philco 604 Bias Cell - by Radioroslyn - 03-30-2018, 12:22 PM
RE: Philco 604 Bias Cell - by mboessen - 03-30-2018, 07:41 PM
RE: Philco 604 Bias Cell - by Arran - 03-31-2018, 02:20 AM
RE: Philco 604 Bias Cell - by mboessen - 03-31-2018, 10:32 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently no members online.

>