Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 20 Restoration
#24

Steve, since you are not adverse to applying modifications I thought you might find these two articles I found interesting.  Popular Science has all of their issues online to read.  In the July 1933 issue, pages 51-53, there are two articles I found curious.  One was a simple way to add a tone control to a radio (model 20?), and the other was modifications to use more advanced output tubes.  The only concern I had was if the tube conversions would overtax the capability of the power transformer.  If nothing else, interesting reading.  Take care, Gary.

"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan


Messages In This Thread
Philco 20 Restoration - by Steve Davis - 02-26-2018, 11:21 PM
RE: Philco 20 Restoration - by morzh - 02-26-2018, 11:56 PM
RE: Philco 20 Restoration - by Steve Davis - 02-27-2018, 12:44 AM
RE: Philco 20 Restoration - by morzh - 02-27-2018, 12:50 AM
RE: Philco 20 Restoration - by Steve Davis - 02-27-2018, 12:00 PM
RE: Philco 20 Restoration - by Nathan Slingerland - 02-27-2018, 12:03 PM
RE: Philco 20 Restoration - by Steve Davis - 02-27-2018, 12:09 PM
RE: Philco 20 Restoration - by Nathan Slingerland - 02-27-2018, 12:14 PM
RE: Philco 20 Restoration - by Steve Davis - 02-27-2018, 01:08 PM
RE: Philco 20 Restoration - by Steve Davis - 02-27-2018, 09:54 PM
RE: Philco 20 Restoration - by Steve Davis - 03-04-2018, 10:50 AM
RE: Philco 20 Restoration - by morzh - 03-04-2018, 11:16 AM
RE: Philco 20 Restoration - by Steve Davis - 03-04-2018, 11:47 AM
RE: Philco 20 Restoration - by morzh - 03-04-2018, 12:43 PM
RE: Philco 20 Restoration - by Arran - 03-04-2018, 07:43 PM
RE: Philco 20 Restoration - by GarySP - 03-27-2018, 11:39 AM
RE: Philco 20 Restoration - by Steve Davis - 03-27-2018, 06:37 PM
RE: Philco 20 Restoration - by Ron Ramirez - 03-27-2018, 07:07 PM
RE: Philco 20 Restoration - by Steve Davis - 03-27-2018, 07:34 PM
RE: Philco 20 Restoration - by Ron Ramirez - 03-27-2018, 07:55 PM
RE: Philco 20 Restoration - by GarySP - 03-28-2018, 08:39 AM
RE: Philco 20 Restoration - by Steve Davis - 03-28-2018, 06:45 PM
RE: Philco 20 Restoration - by GarySP - 03-29-2018, 08:46 AM
RE: Philco 20 Restoration - by GarySP - 03-31-2018, 02:33 PM
RE: Philco 20 Restoration - by Steve Davis - 04-01-2018, 09:17 AM
RE: Philco 20 Restoration - by mg34.42 - 04-28-2019, 11:27 PM
RE: Philco 20 Restoration - by Radioroslyn - 04-29-2019, 12:41 AM
RE: Philco 20 Restoration - by Ron Ramirez - 05-04-2019, 01:08 PM
RE: Philco 20 Restoration - by Radioroslyn - 05-04-2019, 04:51 PM
RE: Philco 20 Restoration - by GarySP - 05-04-2019, 06:13 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM

[-]
Who's Online
There are currently 1020 online users. [Complete List]
» 4 Member(s) | 1016 Guest(s)
AvatarAvatarAvatarAvatar

>