Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

47 1230 no fm
#31

Hi everyone. I need a picture of the 9 lug terminal strip running parallel to the bandswitch. I think there are some wires are wrong, including c419 connections. I removed c419 connections and now have hi voltage back after r100. Any help would be greatly appreciated. Thank you,Bill


Messages In This Thread
47 1230 no fm - by willydcamaro - 01-31-2018, 05:35 PM
RE: 47 1230 no fm - by klondike98 - 01-31-2018, 07:32 PM
RE: 47 1230 no fm - by Warren - 02-01-2018, 07:21 PM
RE: 47 1230 no fm - by willydcamaro - 02-03-2018, 10:02 AM
RE: 47 1230 no fm - by willydcamaro - 02-07-2018, 07:10 PM
RE: 47 1230 no fm - by klondike98 - 02-07-2018, 07:34 PM
RE: 47 1230 no fm - by willydcamaro - 02-07-2018, 07:50 PM
RE: 47 1230 no fm - by klondike98 - 02-07-2018, 08:01 PM
RE: 47 1230 no fm - by Ron Ramirez - 02-07-2018, 08:14 PM
RE: 47 1230 no fm - by willydcamaro - 02-07-2018, 08:31 PM
RE: 47 1230 no fm - by willydcamaro - 02-08-2018, 06:10 AM
RE: 47 1230 no fm - by willydcamaro - 02-09-2018, 05:43 PM
RE: 47 1230 no fm - by Ron Ramirez - 02-09-2018, 06:44 PM
RE: 47 1230 no fm - by willydcamaro - 02-11-2018, 02:53 PM
RE: 47 1230 no fm - by Radioroslyn - 02-11-2018, 04:10 PM
RE: 47 1230 no fm - by willydcamaro - 02-11-2018, 05:47 PM
RE: 47 1230 no fm - by willydcamaro - 03-31-2018, 08:32 AM
RE: 47 1230 no fm - by Radioroslyn - 03-31-2018, 11:04 AM
RE: 47 1230 no fm - by willydcamaro - 03-31-2018, 11:16 AM
RE: 47 1230 no fm - by willydcamaro - 03-31-2018, 05:17 PM
RE: 47 1230 no fm - by Radioroslyn - 03-31-2018, 06:00 PM
RE: 47 1230 no fm - by willydcamaro - 03-31-2018, 07:37 PM
RE: 47 1230 no fm - by willydcamaro - 03-31-2018, 08:39 PM
RE: 47 1230 no fm - by Radioroslyn - 03-31-2018, 08:55 PM
RE: 47 1230 no fm - by willydcamaro - 03-31-2018, 09:03 PM
RE: 47 1230 no fm - by Radioroslyn - 03-31-2018, 09:13 PM
RE: 47 1230 no fm - by willydcamaro - 03-31-2018, 09:31 PM
RE: 47 1230 no fm - by Radioroslyn - 03-31-2018, 09:55 PM
RE: 47 1230 no fm - by willydcamaro - 04-05-2018, 11:41 PM
RE: 47 1230 no fm - by willydcamaro - 04-06-2018, 05:08 AM
RE: 47 1230 no fm - by willydcamaro - 04-07-2018, 07:13 PM
RE: 47 1230 no fm - by willydcamaro - 04-09-2018, 07:52 PM
RE: 47 1230 no fm - by willydcamaro - 04-30-2018, 07:44 PM
RE: 47 1230 no fm - by Marsupial - 08-01-2018, 07:17 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6145 online users. [Complete List]
» 2 Member(s) | 6143 Guest(s)
AvatarAvatar

>