Philco 37-610 tombstone restoration
Posts: 72
Threads: 2
Joined: Jan 2018
City: Madrid, Spain
Ok! I have tried with 90vac and rectifier on place, switch on and nothing made smoke  checking the tubes all filaments are normal, 5Y4 is hot but less than first try and now I can see a small glow in what I think are the filaments in both sides of the black "shields" inside the glass(first try nothing), checked the voltage in #56 and is arround 250vdc, the schematics say something arround 330vdc I will try later to go full voltage and I will tell here the results. Thanks again for the help to get back to life this radio!
Messages In This Thread
RE: Philco 37-610 tombstone restoration - by Jeepeto - 04-09-2018, 09:55 AM
Users browsing this thread: 5 Guest(s)
|
Recent Posts
|
My Philco 37-116 Restore
|
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM |
My Philco 37-116 Restore
|
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM |
Philco 610B oscillator wiring
|
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM |
Refinishing Ideas
|
My 37-116 code 121 is the best sounding radio i have...a daily driver. Since we are talking about "changes". ...poulsbobill — 07:18 PM |
My Philco 37-116 Restore
|
Hello, I finally got brave enough to take the cans off the Expander Unit. Got the grid cap wires replaced and back toget...dconant — 06:50 PM |
Zenith H725
|
I got into the first AM IF can today, and found its mica was cracked. Amazing that it was still working. This one makes ...EdHolland — 06:10 PM |
Philco model #20
|
AHH HA , I got it and can’t thank you fellows enough , when I changed the capacitors I took the advice and did not unsol...onlyrick — 02:24 PM |
Zenith H725
|
Hello Ed,
yes, I like letting projects run for few days to make sure they don't start acting up .
Sincerely Richardradiorich — 01:03 PM |
Philco 46-480 Electronic Restoration
|
I am almost finished with this restoration. All which remains is the power transformer. I cleaned it up some time ago, b...jrblasde — 12:41 PM |
Philco model #20
|
I seem to recall in some TRF sets there being a Local/Distance toggle switch that removes the B+ from the first 24 rf tu...RodB — 09:46 AM |
Who's Online
|
There are currently no members online. |
|

|