[rfeenstra]

Chassis is ready for re-chroming.  All of the tube sockets, terminal strips, and controls were remove with as much wiring intact as possible, hoping to make re-construction as easy as possible. Looks like a rat's nest to me!

All caps will be re-stuffed.  Most of the resistors are easily within specs so I'll leave them.  The power resistor has an open section so I'll have to strap on a wire wound - bummer.  Does anyone know how to rewind these things?

How about the dial face.  Everything is embossed.  However, I don't know how to clean it up without damaging the ink or whatever is in the embossed area for the numbers.  Any ideas or experience out there?

Thanks!