Silvertone 4586 Console

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Silvertone 4586 Console

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#34

04-25-2018, 09:02 PM

Actually the length of a full wave doublet is 1148' I roughed a 1/4 wave @ 300' (287'). Your four footer is going to be good for the fmbcb.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Silvertone 4586 Console - by murf - 02-19-2018, 11:05 PM

RE: Silvertone 4586 Console - by Paul Philco322 - 02-25-2018, 09:41 PM

RE: Silvertone 4586 Console - by Arran - 02-25-2018, 10:09 PM

RE: Silvertone 4586 Console - by murf - 02-25-2018, 11:59 PM

RE: Silvertone 4586 Console - by Radioroslyn - 02-26-2018, 12:30 AM

RE: Silvertone 4586 Console - by murf - 02-26-2018, 06:40 PM

RE: Silvertone 4586 Console - by tbone - 02-26-2018, 08:15 PM

RE: Silvertone 4586 Console - by murf - 02-26-2018, 08:41 PM

RE: Silvertone 4586 Console - by Arran - 03-09-2018, 04:29 AM

RE: Silvertone 4586 Console - by murf - 03-09-2018, 01:35 PM

RE: Silvertone 4586 Console - by murf - 03-14-2018, 06:22 PM

RE: Silvertone 4586 Console - by Arran - 03-15-2018, 04:45 AM

RE: Silvertone 4586 Console - by Arran - 03-17-2018, 08:41 PM

RE: Silvertone 4586 Console - by murf - 03-18-2018, 11:26 AM

RE: Silvertone 4586 Console - by Arran - 03-26-2018, 01:51 AM

RE: Silvertone 4586 Console - by murf - 03-26-2018, 04:11 PM

RE: Silvertone 4586 Console - by murf - 03-26-2018, 10:32 PM

RE: Silvertone 4586 Console - by murf - 03-27-2018, 09:58 PM

RE: Silvertone 4586 Console - by murf - 04-03-2018, 03:31 PM

RE: Silvertone 4586 Console - by Radioroslyn - 04-03-2018, 04:30 PM

RE: Silvertone 4586 Console - by murf - 04-03-2018, 05:58 PM

RE: Silvertone 4586 Console - by morzh - 04-03-2018, 08:28 PM

RE: Silvertone 4586 Console - by murf - 04-03-2018, 09:44 PM

RE: Silvertone 4586 Console - by Arran - 04-05-2018, 04:46 AM

RE: Silvertone 4586 Console - by murf - 04-05-2018, 03:37 PM

RE: Silvertone 4586 Console - by Phlogiston - 04-05-2018, 04:11 PM

RE: Silvertone 4586 Console - by Arran - 04-06-2018, 12:02 AM

RE: Silvertone 4586 Console - by murf - 04-08-2018, 01:25 PM

RE: Silvertone 4586 Console - by murf - 04-17-2018, 08:17 PM

RE: Silvertone 4586 Console - by Radioroslyn - 04-17-2018, 09:43 PM

RE: Silvertone 4586 Console - by murf - 04-24-2018, 06:40 PM

RE: Silvertone 4586 Console - by Radioroslyn - 04-24-2018, 08:52 PM

RE: Silvertone 4586 Console - by murf - 04-25-2018, 08:04 PM

RE: Silvertone 4586 Console - by Radioroslyn - 04-25-2018, 09:02 PM

RE: Silvertone 4586 Console - by murf - 05-01-2018, 06:04 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

Who's Online

There are currently 5195 online users. [Complete List]
» 3 Member(s) | 5192 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me