1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 41-608 cabinet refinish
klondike98
Phorum Moderator
******
Posts: 5,088
Threads: 270
Joined: Nov 2012
City: Wilsonville State, Province, Country: OR
#5

04-26-2018, 09:53 PM
Just keep in mind that Klean Strip contains methylene chloride, a solvent that is on the "probable" carcinogen list, so you should use chemical resistant gloves, safety glasses and work outdoors to keep inhalation as low as possible. There are also acute toxicity issues if exposure levels are too high.
Here's the Safety Data Sheet for it: https://www.homedepot.com/catalog/pdfIma...669423.pdf

You don't need to be afraid of it, just be smart about using it.
Cheers,
Bob
[Image: https://www.dropbox.com/s/5m63ib99yfx2eg....jpg?raw=1]
Bob's Restorations Web Page
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 41-608 cabinet refinish - by Fred Taylor - 04-22-2018, 02:54 PM
RE: Philco 41-608 cabinet refinish - by loepke72 - 04-25-2018, 11:24 AM
RE: Philco 41-608 cabinet refinish - by loepke72 - 04-26-2018, 08:52 PM
RE: Philco 41-608 cabinet refinish - by klondike98 - 04-26-2018, 09:53 PM
RE: Philco 41-608 cabinet refinish - by loepke72 - 04-28-2018, 06:58 PM
RE: Philco 41-608 cabinet refinish - by sam - 04-29-2018, 01:34 PM
RE: Philco 41-608 cabinet refinish - by morzh - 05-10-2018, 09:04 AM
RE: Philco 41-608 cabinet refinish - by sam - 05-10-2018, 01:32 PM
RE: Philco 41-608 cabinet refinish - by tbone - 05-10-2018, 05:35 PM
RE: Philco 41-608 cabinet refinish - by mark123 - 10-26-2018, 01:15 PM
RE: Philco 41-608 cabinet refinish - by mark123 - 10-29-2018, 02:23 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3456 online users. [Complete List]
» 2 Member(s) | 3454 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration