Posts: 4,639
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
If the cabinet isn't too bad, then anywhere between $50 and $100 is reasonable, more if the finish is really nice, and the set is all complete with good major parts. But I would see how much lower then $85 you can get, these are fairly complex radios, roughly equivalent to a Philco 116, but they often have rubber/gutta percha covered wire, and the power transformers have been known to fail sometimes. On that last point I would bring a multimeter with you and check the transformer windings, you can do this at the rectifier tube socket. Even if you want to gamble it is a set well worth restoring, even if you had to replace that, but if it is shot then you can negotiate more off the price, they always need more then just a power cord, or a tube, always.
Regards
Arran
(This post was last modified: 04-27-2018, 03:16 AM by Arran.)
Messages In This Thread
RE: RCA 10T - by Arran - 04-27-2018, 03:15 AM
Users browsing this thread: 5 Guest(s)
|
Recent Posts
|
PT-6 antenna connections
|
Hi Bridcarl
+1 on the others. Pin 6 of the 7C6 is the AVC Diode so it is appropriate that that pin 4 of the coil con...MrFixr55 — 07:30 AM |
462ron
|
Joseph, this is beyond awesome. A lot of thought and engineering went into this and you hit a home run! Now I must save ...462ron — 07:27 AM |
Cannot Adjust an IF Transformer’s cores
|
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM |
Cannot Adjust an IF Transformer’s cores
|
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM |
PT-6 antenna connections
|
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM |
Cannot Adjust an IF Transformer’s cores
|
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM |
PT-6 antenna connections
|
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4.
Yes, pin 6 of the 7C6 is...RodB — 07:34 PM |
bridkarl
|
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM |
Cannot Adjust an IF Transformer’s cores
|
Joseph, now you are an engineer!!RodB — 06:37 PM |
PT-6 antenna connections
|
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM |
Who's Online
|
There are currently no members online. |
|
![>](https://philcoradio.com/phorum/images/bootbb/asb/right_arrow.png)
|