1934 Philco 60B Alignment Problem

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

1934 Philco 60B Alignment Problem

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

05-01-2018, 01:11 PM

You can check itw/an ohm meter BUT most of the time it's in parallel w/a low resistance coil (like 3 or 4 ohms) so what you a looking for is very low resistance if the plates are rubbing (like .1 ohm). A few ohms is pretty normal.

GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

1934 Philco 60B Alignment Problem - by whirligig - 04-26-2018, 11:02 PM

RE: 1934 Philco 60B Alignment Problem - by PhilcoPhan1936 - 04-27-2018, 03:22 AM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 04-27-2018, 01:18 PM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 04-30-2018, 02:02 PM

RE: 1934 Philco 60B Alignment Problem - by morzh - 04-30-2018, 04:12 PM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 04-30-2018, 07:38 PM

RE: 1934 Philco 60B Alignment Problem - by morzh - 05-01-2018, 11:48 AM

RE: 1934 Philco 60B Alignment Problem - by Radioroslyn - 05-01-2018, 01:11 PM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 05-01-2018, 02:46 PM

RE: 1934 Philco 60B Alignment Problem - by Radioroslyn - 05-01-2018, 04:23 PM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 05-01-2018, 04:43 PM

RE: 1934 Philco 60B Alignment Problem - by Radioroslyn - 05-01-2018, 04:51 PM

RE: 1934 Philco 60B Alignment Problem - by Ron Ramirez - 05-01-2018, 10:19 PM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 05-02-2018, 01:39 AM

RE: 1934 Philco 60B Alignment Problem - by Radioroslyn - 05-02-2018, 11:32 AM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 05-02-2018, 02:10 PM

RE: 1934 Philco 60B Alignment Problem - by Steve Davis - 05-03-2018, 07:39 PM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 05-03-2018, 08:28 PM

RE: 1934 Philco 60B Alignment Problem - by Ron Ramirez - 05-03-2018, 09:51 PM

RE: 1934 Philco 60B Alignment Problem - by Arran - 05-04-2018, 12:24 AM

RE: 1934 Philco 60B Alignment Problem - by whirligig - 05-05-2018, 01:14 AM

View a Printable Version

Users browsing this thread: 7 Guest(s)

Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit. That would rem...alangard — 09:30 PM

Who's Online

There are currently 6230 online users. [Complete List]
» 2 Member(s) | 6228 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me