Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Difference in Schematic and chassis cap values?
#1

First post! Been reading for quite awhile but now need a little guidance.  My background: Retired Navy electronics type however that was 25 yrs ago.  So it has been a relearning curve.  I have retained my soldering skills thru several other hobbies over the years.
I am currently refurbing a Molorola 61-CA.  I know this is a Philco forum but I have 3 Philco's on deck.  I choose the Motorola as my first project mainly because I rx it first. lol
So I have found several cases where a cap in the chassis will have a different value than the schematic?  Do you go by the schematic? or is it a case by case situation?  On one of them the cap in place was a different manufacture so I am going to assume someone repaired and that was what they had.  In that case I will go with the schematic.  But for the ones that appear original but don't match is my question I guess.  Thank you for your time and help in advance.  I am enjoying the process so far and am looking fwd to getting to the Philco's.  My favorite I think will be my 610B.  I listen to SW often so this will be a treat I think.
Tt
KK4KRU


Messages In This Thread



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
12' Philco
GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM
Philco Predicta Siesta picture over time getting dimmer
I found that the wire insulation was burnt.  The fly back needs corona dope! Why would someone put that there?Platinumblonde36 — 01:09 AM

[-]
Who's Online
There are currently 5139 online users. [Complete List]
» 1 Member(s) | 5138 Guest(s)
Avatar

>