Kirk's 37-610

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Kirk's 37-610

Jeepeto
Member

Posts: 72
Threads: 2
Joined: Jan 2018
City: Madrid, Spain

05-07-2018, 05:26 PM

Just I have restored one speaker for this same type of radio and the Voice coil (original) was 1,7ohm (I supose 2 ohm will work)
Just in case you need this info.
Good job and keep going

Find

« Next Oldest | Next Newest »

Messages In This Thread

Kirk's 37-610 - by morzh - 03-31-2018, 10:43 PM

RE: Kirk's 37-610 - by morzh - 04-01-2018, 01:24 PM

RE: Kirk's 37-610 - by morzh - 04-16-2018, 11:15 AM

RE: Kirk's 37-610 - by WyTex - 04-16-2018, 11:55 AM

RE: Kirk's 37-610 - by morzh - 04-16-2018, 12:13 PM

RE: Kirk's 37-610 - by WyTex - 04-16-2018, 01:28 PM

RE: Kirk's 37-610 - by morzh - 05-04-2018, 08:36 PM

RE: Kirk's 37-610 - by morzh - 05-05-2018, 07:34 PM

RE: Kirk's 37-610 - by Jeepeto - 05-07-2018, 05:26 PM

RE: Kirk's 37-610 - by morzh - 05-07-2018, 06:10 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me