Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco Hippo 46-620 Code 128
#8

Reminds me of an old radio show called "Let Pretend"
Figure out which tube (s) it uses as Tom mentions and renumber the diagram to match.
From what I remember the big difference between the runs is the spkr
some used pm vs electrodynamic. Not a big deal.

GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco Hippo 46-620 Code 128 - by jamr005 - 05-08-2018, 06:54 PM
RE: Philco Hippo 46-620 Code 128 - by Patrick - 05-08-2018, 08:11 PM
RE: Philco Hippo 46-620 Code 128 - by Ron Ramirez - 05-09-2018, 05:27 AM
RE: Philco Hippo 46-620 Code 128 - by Kestas - 05-09-2018, 12:48 PM
RE: Philco Hippo 46-620 Code 128 - by 35Z5 - 05-09-2018, 02:14 PM
RE: Philco Hippo 46-620 Code 128 - by morzh - 05-09-2018, 02:30 PM
RE: Philco Hippo 46-620 Code 128 - by 35Z5 - 05-09-2018, 05:01 PM
RE: Philco Hippo 46-620 Code 128 - by Radioroslyn - 05-09-2018, 05:25 PM
RE: Philco Hippo 46-620 Code 128 - by David - 05-09-2018, 08:40 PM
RE: Philco Hippo 46-620 Code 128 - by Radioroslyn - 05-09-2018, 09:26 PM
RE: Philco Hippo 46-620 Code 128 - by Arran - 05-09-2018, 11:15 PM
RE: Philco Hippo 46-620 Code 128 - by 35Z5 - 05-10-2018, 09:02 AM
RE: Philco Hippo 46-620 Code 128 - by klondike98 - 05-10-2018, 12:10 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM
Jackson 665 j2 schematic request
Looking for a schematic for the 665 j2 multimeter.daveone23 — 04:42 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
>>I'll write to the Henry Ford. I heard, his secretary answers his mail, not he himself.morzh — 12:15 PM
Philco 48-200 alignment questions
Just checked the power cord and I did in fact wire it so the hot side (small prong) goes to the switch.transitony — 11:52 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
Thanks for the suggestions.  I'll write to the Henry Ford.   That would certainly make sense since by the time this prod...jeibner — 11:49 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
For what it's worth, the Henry Ford Museum and Greenfield Village in Dearborn, Michigan may be an option. The obvious ...GarySP — 11:39 AM
Help with Readrite 410 tube tester
Mike and I just had a short discussion yesterday about this very subject. So often it's the connections. Ya gotta have t...RodB — 10:08 AM
Looking for place to donate unique Philco Philco J-1930 Prototype
We have a regional museum here in the Twin Cities called The Pavek Museum. They have an extensive collection of communic...RodB — 09:30 AM
Philco 89B code 123 newbie
I did some nosing around and found that the original caps were 4 3/4" long x 1 5/16" in dia. Guess what 1"...Radioroslyn — 09:28 AM

[-]
Who's Online
There are currently 4867 online users. [Complete List]
» 2 Member(s) | 4865 Guest(s)
AvatarAvatar

>