1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Started my 41-295x restore.
nortonz
Member
***
Posts: 88
Threads: 17
Joined: May 2018
City: Hayden, ID
#4

05-13-2018, 07:45 PM
Didn't see any way to remove the bars in front of the speaker, so have been sanding around them.
I got most of the sanding done. Just have to get around those post. When I get it done, I will post some more pictures. Then the next faze.
Philco 41-295X 4 band radio.
I'm 67 years old, in north Idaho.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Started my 41-295x restore. - by nortonz - 05-11-2018, 01:19 AM
RE: Started my 41-295x restore. - by nortonz - 05-11-2018, 01:25 AM
RE: Started my 41-295x restore. - by nortonz - 05-11-2018, 05:11 PM
RE: Started my 41-295x restore. - by nortonz - 05-13-2018, 07:45 PM
RE: Started my 41-295x restore. - by Arran - 05-14-2018, 12:06 AM
RE: Started my 41-295x restore. - by nortonz - 05-14-2018, 01:22 PM
RE: Started my 41-295x restore. - by Arran - 05-14-2018, 09:15 PM
RE: Started my 41-295x restore. - by nortonz - 05-15-2018, 02:01 AM
RE: Started my 41-295x restore. - by nortonz - 05-15-2018, 03:37 PM
RE: Started my 41-295x restore. - by Ron Ramirez - 05-15-2018, 06:02 PM
RE: Started my 41-295x restore. - by rfeenstra - 05-16-2018, 12:57 AM
RE: Started my 41-295x restore. - by nortonz - 05-18-2018, 01:42 AM
RE: Started my 41-295x restore. - by nortonz - 06-20-2018, 11:45 PM
RE: Started my 41-295x restore. - by nortonz - 06-30-2018, 12:33 AM
RE: Started my 41-295x restore. - by 1MohrRadio - 12-29-2018, 07:28 AM
RE: Started my 41-295x restore. - by nortonz - 02-10-2019, 01:59 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5124 online users. [Complete List]
» 1 Member(s) | 5123 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration