Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Photo Finish on a 40-180
#5

Take a piece of the veneer, which is falling off anyhow, and compare it to the gallery on the Constantines web site, you will have to either use the unfinished side or strip the finish off the front side, to compare it properly. I think that you may be right about it being Zebrano/Zebra wood, but it could also be quarter sawn French walnut veneer cut with it's grain on the diagonal, it's hard to tell with that light walnut coloured finish they used over everything.
Regards
Arran


Messages In This Thread
Photo Finish on a 40-180 - by Mjeansonne - 05-25-2018, 09:01 AM
RE: Photo Finish on a 40-180 - by nortonz - 05-25-2018, 09:44 AM
RE: Photo Finish on a 40-180 - by klondike98 - 05-25-2018, 10:04 AM
RE: Photo Finish on a 40-180 - by Mjeansonne - 05-26-2018, 11:29 AM
RE: Photo Finish on a 40-180 - by Arran - 05-27-2018, 12:29 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM

[-]
Who's Online
There are currently 5754 online users. [Complete List]
» 1 Member(s) | 5753 Guest(s)
Avatar

>