Line cord 42-1008

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Line cord 42-1008

NostalgiaRadioTime
Super Moderator

Posts: 1,523
Threads: 240
Joined: Sep 2012
City: West Bend, Wisconsin

05-29-2018, 10:47 PM

Had the same experience with those strain relief's, Ron. Too small. I just went with a rubber grommet in the hole through the chassis and a knot in the cord on both sides of the chassis wall.

Greg V.
West Bend, WI
Member WARCI.org

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

Line cord 42-1008 - by soldersucker - 05-29-2018, 04:10 PM

RE: Line cord 42-1008 - by NostalgiaRadioTime - 05-29-2018, 06:30 PM

RE: Line cord 42-1008 - by Ron Ramirez - 05-29-2018, 07:08 PM

RE: Line cord 42-1008 - by Patrick - 05-29-2018, 09:05 PM

RE: Line cord 42-1008 - by NostalgiaRadioTime - 05-29-2018, 10:47 PM

RE: Line cord 42-1008 - by Arran - 05-30-2018, 03:19 AM

RE: Line cord 42-1008 - by Ron Ramirez - 05-30-2018, 06:06 AM

RE: Line cord 42-1008 - by Ed Locker - 05-30-2018, 09:14 AM

RE: Line cord 42-1008 - by soldersucker - 06-09-2018, 09:20 PM

RE: Line cord 42-1008 - by Arran - 06-09-2018, 10:07 PM

RE: Line cord 42-1008 - by soldersucker - 06-10-2018, 07:55 AM

RE: Line cord 42-1008 - by soldersucker - 06-10-2018, 08:50 AM

RE: Line cord 42-1008 - by mikethedruid - 06-10-2018, 03:49 PM

RE: Line cord 42-1008 - by soldersucker - 06-10-2018, 08:09 PM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me