Now to dive in!

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Now to dive in!

Paul Philco322
Super Moderator

Posts: 4,384
Threads: 412
Joined: Jun 2011
City: Boston State, Province, Country: Massachusetts

06-03-2018, 09:12 AM

That is a fine looking set, so often the dials run left to right it is a bit different to see a dial that is square and works by pointer turning.

Paul

Tubetalk1

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

Now to dive in! - by Desmoduece - 06-01-2018, 02:42 PM

RE: Now to dive in! - by morzh - 06-01-2018, 04:50 PM

RE: Now to dive in! - by Desmoduece - 06-01-2018, 05:58 PM

RE: Now to dive in! - by klondike98 - 06-01-2018, 07:40 PM

RE: Now to dive in! - by Nathan Slingerland - 06-02-2018, 01:17 AM

RE: Now to dive in! - by NickinMD - 06-02-2018, 06:47 AM

RE: Now to dive in! - by Desmoduece - 06-02-2018, 09:02 AM

RE: Now to dive in! - by Paul Philco322 - 06-03-2018, 09:12 AM

View a Printable Version

Users browsing this thread: 5 Guest(s)

Recent Posts
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM
Philco 60 Squealing
I have been playing the radio for a while now and doing well. Turned it on today and all I got was a whole lot of noise....dconant — 09:39 AM
Rusty Tuning Condenser
Thanks guys. I think I'll give the Naval Jelly a try since I can better control where it goes.dconant — 09:23 AM
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM

Who's Online

There are currently 3770 online users. [Complete List]
» 2 Member(s) | 3768 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me