restoring 38-12

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

restoring 38-12

LarryFS
Member

Posts: 120
Threads: 15
Joined: Aug 2017
City: Fort Worth State, Province, Country: TX

06-24-2018, 10:12 AM

One other thing - Item 30 in the parts list is a bakelite block that has two .01 mfd capacitors in it. Those should also be replaced. If you have never replaced caps in a bakelite block, take a look at Philco Bakelite Block Condenser Data in the Philco Tech Section of the Phorum.

(This post was last modified: 06-24-2018, 10:39 AM by LarryFS.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

restoring 38-12 - by buckeye - 06-23-2018, 07:26 PM

RE: restoring 38-12 - by morzh - 06-23-2018, 08:34 PM

RE: restoring 38-12 - by LarryFS - 06-23-2018, 09:18 PM

RE: restoring 38-12 - by buckeye - 06-24-2018, 06:49 AM

RE: restoring 38-12 - by LarryFS - 06-24-2018, 10:12 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me