Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Delco/RCA same chassis
#2

I have read that Delco was headquartered in Detroit in the GM Building, however manufacturing was done at a plant in Kokomo IN. Some sets were made by other makers, RCA one of them. I have a Delco 1212 and it has an internal antenna eerily similar to an RCA 35X, also uses the same wooden bumpers between antenna and chassis, and has the same knobs as some of my RCA's. So that may be your answer. RCA.

My 1212 is a fine player like most of my other 6 tube RCA sets. Maybe have you tried comparing schematics to a similar RCA from that model year or so?

Good luck,

Paul

Tubetalk1


Messages In This Thread
Delco/RCA same chassis - by lasurveyor - 06-04-2018, 11:52 AM
RE: Delco/RCA same chassis - by Paul Philco322 - 06-25-2018, 08:45 PM
RE: Delco/RCA same chassis - by Brad Winder - 06-26-2018, 12:08 AM
RE: Delco/RCA same chassis - by Arran - 06-26-2018, 04:33 AM
RE: Delco/RCA same chassis - by Paul Philco322 - 06-26-2018, 08:46 AM
RE: Delco/RCA same chassis - by lasurveyor - 06-26-2018, 11:01 AM
RE: Delco/RCA same chassis - by Paul Philco322 - 06-26-2018, 11:57 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

[-]
Who's Online
There are currently 5662 online users. [Complete List]
» 1 Member(s) | 5661 Guest(s)
Avatar

>