[Eric]

So this is where I'm at.
1 replaced the most of the caps (except those in the molded block) and resistors that were out of spec.
2 I'm using the one 41 as it was set up. 
3 wired the speaker socket per your print.
4 the set powers up and for the most part I get good voltages,
5 On the 37 # 3pin I get feed back through the speaker as well as the Vol and Tone pot
6 tried to put a signal through the ant but nothing.
here is the voltage chart I see a problem with the 6A7 pin 5