Hello! - Philco L-1679 Question

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Hello! - Philco L-1679 Question

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

07-12-2018, 01:23 PM

Hi & welcome,
Schematic is here. http://www.rsp-italy.it/Electronics/Radi.../index.htm Click on 1964 and scroll down to page 129.

GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Hello! - Philco L-1679 Question - by koonce0313 - 07-12-2018, 10:56 AM

RE: Hello! - Philco L-1679 Question - by morzh - 07-12-2018, 11:55 AM

RE: Hello! - Philco L-1679 Question - by koonce0313 - 07-12-2018, 01:11 PM

RE: Hello! - Philco L-1679 Question - by Radioroslyn - 07-12-2018, 01:23 PM

RE: Hello! - Philco L-1679 Question - by morzh - 07-12-2018, 02:24 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me