1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
37-604 Repair Project
radioalfa
Junior Member
**
Posts: 18
Threads: 3
Joined: Nov 2014
City: Groveland MA
#2

07-20-2018, 08:51 AM
Things are progressing, slowly but surely. The electrolytics are in their can and connected, the 25Z6 tube socket has been replaced, 3 of the 4 bakelite blocks have been rebuilt.

I have a question on R20, the parts list shows it as being a 200 Ohm wire wound resistor, part number 33-3010, the schematic shows it as being 300 Ohms. Any idea which one is should be?
It measures 329 Ohms.

Russ
Find
« Next Oldest | Next Newest »


Messages In This Thread
37-604 Repair Project - by radioalfa - 07-14-2018, 08:11 PM
RE: 37-604 Repair Project - by radioalfa - 07-20-2018, 08:51 AM
RE: 37-604 Repair Project - by PhilcoPhan1936 - 07-20-2018, 01:38 PM
RE: 37-604 Repair Project - by Radioroslyn - 07-20-2018, 04:06 PM
RE: 37-604 Repair Project - by radioalfa - 07-20-2018, 04:49 PM
RE: 37-604 Repair Project - by radioalfa - 07-22-2018, 09:18 PM
RE: 37-604 Repair Project - by radioalfa - 08-04-2018, 08:44 PM
RE: 37-604 Repair Project - by Radioroslyn - 08-04-2018, 09:48 PM
RE: 37-604 Repair Project - by radioalfa - 08-07-2018, 07:40 AM
RE: 37-604 Repair Project - by Ron Ramirez - 08-07-2018, 10:41 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM

[-]
Who's Online
There are currently 4375 online users. [Complete List]
» 3 Member(s) | 4372 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration