1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 38-7
Arran
Phorum Expert
*****
Posts: 4,705
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA
#14

08-13-2018, 09:38 PM
That's the line capacitors, if it shorts out it won't do anything other then blow a fuse, or if leaky heat up and melt tar, it should not harm the transformer primary and definitely not harm the H.V secondary. On this set it's ahead of the power switch, so as long as the set is plugged in it has power across the caps all the time, actually between each side of the power line and the chassis, so it can go without the set even being on. 
Regards
Arran
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 38-7 - by PhilcoPhan1936 - 08-09-2018, 02:50 PM
RE: Philco 38-7 - by Olskuul - 08-09-2018, 05:10 PM
RE: Philco 38-7 - by Radioroslyn - 08-09-2018, 06:08 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-09-2018, 09:47 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-10-2018, 05:40 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-10-2018, 06:09 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 05:03 PM
RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 05:30 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 05:48 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 06:11 PM
RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 06:55 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 07:23 PM
RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 09:22 PM
RE: Philco 38-7 - by Arran - 08-13-2018, 09:38 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 04:17 AM
RE: Philco 38-7 - by Ron Ramirez - 08-14-2018, 06:25 AM
RE: Philco 38-7 - by Radioroslyn - 08-14-2018, 08:28 AM
RE: Philco 38-7 - by cpollock - 08-14-2018, 12:30 PM
RE: Philco 38-7 - by Radioroslyn - 08-14-2018, 01:01 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 04:35 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 05:40 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 10:49 PM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-27-2018, 03:34 AM
RE: Philco 38-7 - by PhilcoPhan1936 - 08-27-2018, 07:54 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration