Philco 38-7

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 38-7

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#19

08-14-2018, 01:01 PM

Hi Clif,
The 6J5 isn't going to have any HV applied to it as it's being used a a detector/avc diode. The only voltage found there is going to be a small amount of ac (the rf signal from the IF stage).

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 38-7 - by PhilcoPhan1936 - 08-09-2018, 02:50 PM

RE: Philco 38-7 - by Olskuul - 08-09-2018, 05:10 PM

RE: Philco 38-7 - by Radioroslyn - 08-09-2018, 06:08 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-09-2018, 09:47 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-10-2018, 05:40 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-10-2018, 06:09 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 05:03 PM

RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 05:30 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 05:48 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 06:11 PM

RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 06:55 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-13-2018, 07:23 PM

RE: Philco 38-7 - by Radioroslyn - 08-13-2018, 09:22 PM

RE: Philco 38-7 - by Arran - 08-13-2018, 09:38 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 04:17 AM

RE: Philco 38-7 - by Ron Ramirez - 08-14-2018, 06:25 AM

RE: Philco 38-7 - by Radioroslyn - 08-14-2018, 08:28 AM

RE: Philco 38-7 - by cpollock - 08-14-2018, 12:30 PM

RE: Philco 38-7 - by Radioroslyn - 08-14-2018, 01:01 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 04:35 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 05:40 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-14-2018, 10:49 PM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-27-2018, 03:34 AM

RE: Philco 38-7 - by PhilcoPhan1936 - 08-27-2018, 07:54 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 7189 online users. [Complete List]
» 4 Member(s) | 7185 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me