Radiobar

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Radiobar

Nathan Slingerland
Super Moderator

Posts: 1,874
Threads: 212
Joined: May 2015
City: Seattle State, Province, Country: WA

08-24-2018, 11:05 AM

Welcome John!

Is the radio still there? Additional photos of the front panel as well as the chassis / speaker would likely help with the identification.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Radiobar - by Johnboy17 - 08-24-2018, 10:41 AM

RE: Radiobar - by Nathan Slingerland - 08-24-2018, 11:05 AM

RE: Radiobar - by wardmc1 - 08-24-2018, 11:21 AM

RE: Radiobar - by Johnboy17 - 08-24-2018, 11:23 AM

RE: Radiobar - by Johnboy17 - 08-24-2018, 11:27 AM

RE: Radiobar - by wardmc1 - 08-24-2018, 12:28 PM

RE: Radiobar - by Johnboy17 - 08-24-2018, 12:33 PM

RE: Radiobar - by OldRestorer - 08-29-2018, 10:27 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me