Zenith 10A1

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Zenith 10A1

tbone
Senior Member

Posts: 279
Threads: 19
Joined: Nov 2016
City: Cromwell State, Province, Country: CT

08-28-2018, 06:04 AM

Should be a good performing 1940 radio. Has built in wavemagnet Antenna and an RF stage. You are right that it has the dual 6X5 rectifier arrangement, but that can be dealt with. Just beware it might have rubber wiring, but don’t let the scare you. Just don’t power up till recapped and serviced.

http://www.nostalgiaair.org/pagesbymodel...024676.pdf

Tony

“People may not remember how fast you did a job, but they will remember how well you did it”

Find

« Next Oldest | Next Newest »

Messages In This Thread

Zenith 10A1 - by rfeenstra - 08-27-2018, 10:16 PM

RE: Zenith 10A1 - by morzh - 08-27-2018, 10:27 PM

RE: Zenith 10A1 - by Paul Philco322 - 08-27-2018, 10:33 PM

RE: Zenith 10A1 - by tbone - 08-28-2018, 06:04 AM

RE: Zenith 10A1 - by Chas - 08-28-2018, 11:00 AM

RE: Zenith 10A1 - by rfeenstra - 08-28-2018, 10:18 PM

RE: Zenith 10A1 - by Arran - 08-29-2018, 02:39 AM

RE: Zenith 10A1 - by Eliot Ness - 08-29-2018, 07:48 AM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me