Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-610 Speaker Wiring Replacement
#2

Hi Gary

I know someone in the r.a.r+p newsgroup has already answered this for you, but 18 or even 20 gauge would be quite sufficient for what you're doing. If you wanted to use the repro cloth-covered wire from Radio Daze, you could get a piece of green, a piece of white, and a piece of blue, and be almost authentic. I've used 20 gauge cloth-covered wire for speakers in the past and never had an issue with them. I'm out of the stuff now, though, else I would send you three wires, sorry.

If you don't go the cloth-covered route, plastic insulated wire of 18 or 20 gauge will serve the purpose.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
37-610 Speaker Wiring Replacement - by n9vu - 02-02-2006, 11:21 PM
[No subject] - by Ron Ramirez - 02-05-2006, 09:27 AM
[No subject] - by n9vu - 02-05-2006, 12:21 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 998 online users. [Complete List]
» 2 Member(s) | 996 Guest(s)
AvatarAvatar

>